Starting the Motor
-
mortimerPAS
- Moderator
- Posts: 125
- Joined: Sun Sep 15, 2019 8:45 pm
Hello, I am the proud owner of a 2016 First Edition Kia Sportage. I recently had my automobile serviced by my dad, and this problem has persisted for a while; however, it only occurs after a few hours of inactivity or on chilly mornings. I ran a diagnostic to put the EPB into service mode and checked for any possible codes, but I didn't find any. Even after switching to a fresh battery, the problem remained. Based on my limited understanding, I would have assumed that the glow plugs were to blame, but by the time I would have driven down to the garage to drop it off, it would have started without a hitch. Plus, I didn't have the time to leave it with them for the weekend (work, etc.). Why is the starter motor not turning over? Uncertain about anything else...
-
mortimerPAS
- Moderator
- Posts: 125
- Joined: Sun Sep 15, 2019 8:45 pm
Any information would be greatly appreciated.
I appreciate it.
I appreciate it.
-
Hunger_for_love
- Moderator
- Posts: 128
- Joined: Tue Mar 10, 2020 8:44 pm
Not the starter motor, but the engine is clearly cranking.
-
vendimoto55
- Moderator
- Posts: 118
- Joined: Wed May 22, 2019 5:33 pm
Excuse me, but which engine is this?
I take it that diesel is being implied by the use of glow plugs?
While glow plugs aren't necessary for starting in the summer, they can be a problem when temperatures drop below freezing. This is especially true with modern common rail diseases.
Leaks in the fuel feed system or injectors would be my first guess.
It can help to wait until the primer bulb is hard before starting to pump it.
I take it that diesel is being implied by the use of glow plugs?
While glow plugs aren't necessary for starting in the summer, they can be a problem when temperatures drop below freezing. This is especially true with modern common rail diseases.
Leaks in the fuel feed system or injectors would be my first guess.
It can help to wait until the primer bulb is hard before starting to pump it.
-
mortimerPAS
- Moderator
- Posts: 125
- Joined: Sun Sep 15, 2019 8:45 pm
The vehicle in question is a 2-liter diesel engine. Is the location of the priming bulb familiar to you? Much obliged.
-
mortimerPAS
- Moderator
- Posts: 125
- Joined: Sun Sep 15, 2019 8:45 pm
Am I correct in assuming that you do not have one?
So far, every piece of information I've come across points to a fuel pump that can self-prime the system.
However, if air is gradually entering the system, the same holds true.
Before you start the pump, try turning the key on and off many times.
So far, every piece of information I've come across points to a fuel pump that can self-prime the system.
However, if air is gradually entering the system, the same holds true.
Before you start the pump, try turning the key on and off many times.
-
85KillallRU
- Moderator
- Posts: 121
- Joined: Mon Apr 05, 2021 9:28 pm
Two methods exist for starting a diesel engine:"The modern way" means to handle it like petrol and not to touch the accelerator pedal.
For the good ol' days, when you had to physically start the engine, you would have to floor the accelerator pedal before turning the key.
In this particular instance, is it significant?
For the good ol' days, when you had to physically start the engine, you would have to floor the accelerator pedal before turning the key.
In this particular instance, is it significant?
-
JasonLewis93
- Newbie
- Posts: 1
- Joined: Wed Nov 05, 2025 12:14 am
Is there anyone available right now ???