JustCarsForum - Your Ultimate Automotive Community

Secret codes required for escape

For which C-HR generation is this?

Tell me which codes are needed.

Popular U-Codes for the Toyota CAN Gateway

In the event that the Central Gateway Module or the Network Bus experiences a communication loss, the vehicle will record the following standard network DTCs:

When one or more oecus are unable to communicate via the primary CAN bus, it is indicative of a general network failure (U0073 - Control Module Communication Bus "A" Off).
The gateway module lost contact with the main Engine Control Module (ECM/PCM "A"). This is indicated by the U0100 code.
• U0129 - Lost Communication with Brake System Control Module: This happens when the gateway and the ABS/Skid Control ECU are unable to communicate with each other, which often happens when the battery voltage drops while the vehicle is being worked on.
• U0140 - Body Control Module (BCM) Lost Communication: Signal drops between the central processor and the gateway for the body's electronics.
• U1117 - The Accessory Gateway ECU Has Lost Communication: This warning light comes on when an aftermarket device (such as a dashcam, tracker, or display adapter) gets in the way of the accessory CAN lines, or when a connector is removed while the 12V battery is still attached.

---

Crucial Central Gateway (CGW) Communication Details for C-HR

In order to access the gateway's CAN-High and CAN-Low lines, you must:

The Central Gateway Module, which is usually found on the C-HR (TNGA platform) behind the lower dash/driver-side knee bolster area, near or just above the OBD-II diagnostic port, is the primary location designated for the gateway.
• Primary CAN Networks:
- The white wire is typically used for CAN-High (CAN-H).
The CAN-Low (CAN-L) wire is typically red, but it can be black or pink if you're connected to the V-CAN or Central Gateway loop.
• On-Board Diagnostics Port #2:
- CAN-High (Pin 6)
"CAN-Low" (Pin 14) — —

Details Required for Additional Assistance

Specific diagnostic procedures or pinout wiring diagrams can be obtained by:
your diagnostic scanner is displaying the exact DTC code(s).
2. Signs and problems that your C-HR is facing 1.
3. Any modifications made recently, such as the installation of a tracker/immobilizer, an aftermarket stereo box, or a twelve volt flat battery.

The CAN invader theft tool is known to target certain vehicles and products, and a new user is requesting CAN bus information for one of those vehicles or products.

That angle wasn't thought of by me ׭