JustCarsForum - Your Ultimate Automotive Community

Greetings, I have successfully established a connection between the Carly adapter and my automobile. However, I regret to inform you that today I am experiencing a complete malfunction of all vehicle functionalities. Could someone please provide assistance on how to address these issues?

Have you attempted to restore the system to a previous backup? The inclusion of a specific date and the most recent backup date is recommended.

Utilise your most recent "backup" and initiate a restoration process to revert to the most recent known stable state.

Despite my attempts, they still received a response. The BMW repair centre identified a faulty ABS sensor, which was not detected by the automobile prior to undergoing a diagnostic examination.

What actions need to be taken in order to reproduce this problem with Carly? Do you own any other equipment comparable to an Ethernet cable?

No, I do not possess such knowledge. However, I have merely conducted a vehicle diagnostic. The vehicle was brought to a BMW service centre where the issue was successfully resolved. The issue was caused by the ABS ring. The vehicle remained unaware of the issue until a diagnostic examination was conducted.
I would be happy to assist you in rewriting your text to make it more academic. However

There is no evidence to suggest that the ABS ring may deteriorate based on diagnostic findings. However, it is possible for the FRM3 module (if installed) to malfunction as a result of low voltage during diagnostic procedures. Nonetheless, this specific scenario does not include the ABS ring.

The diagnostic results do not provide any evidence to support the claim that the ABS ring may degrade. Nevertheless, it is conceivable that the FRM3 module, in the event of its installation, may experience a failure due to insufficient voltage when undergoing diagnostic processes. However, it should be noted that the ABS ring is not present in this particular circumstance.

The vehicle was reprogrammed using default configurations in the ISTA software, and the responsibility for any issues was attributed to a faulty sensor.
In the event of a malfunctioning sensor, an ABS fault will be shown on the display.