Automotive proximity sensors

[Isabella_Martin2002]

Can parking sensors be installed on a 2015 Aygo? If so, does anybody know the cost of installation?

In my opinion, the rear camera lacks use due to the absence of guide lines and the inability to accurately determine the distance from an object. Consequently, I would prefer the implementation of parking sensors.

[Thomas_Green78]

Affirmative, parking sensors may be installed on any vehicle. You may have your tow bar installed by a local tow bar installer or even by Halfords.

The camera should possess guidelines, nevertheless, similar to other individuals here, mine are not properly aligned. By following the recommendations, the automobile is parked at an inclined angle when I reverse. I will schedule a servicing appointment for the camera in a few weeks, at which I will specifically request for the camera to be adjusted. I expect there will be some opposition to doing it.

[Sophia_Williams99]

Initially, early 2nd generation Aygos did not come equipped with guide lines. However, starting from around 2016, guide lines were installed. Our 2016 model has this feature.

[almamater78]

I still like the traditional method of visually inspecting my alignment with a parking place by opening the door and using my own eyes, rather than relying on the camera tramlines. The answer to this question hinges on whether or not you had initial access to these technologies as a novice driver. Our ability to adapt to and use the resources available to us is often shaped by our early experiences.

[dontito]

I seldom adhere to the requirements since they do not align with the majority of parking places. I depend on the mirrors, particularly the blindspot enhancements, and I use the camera as a secondary measure to ensure there is no obstruction behind me, in addition to the rearview mirror, which is self-evident.

[DivineStripe]

I have installed rear parking sensors on around six MkII Aygo/C1/108 vehicles. I use CISBO four-sensor kits that need a 21mm aperture in the bumper, with a total diameter of 25mm. The kit is priced at around £20 and demonstrates effective performance and reliability. Over the last 4-5 years, I have installed more than 30 of these kits on various automobiles. The kit is priced at around £20 and demonstrates effective performance and reliability. There are around 32 different hues available, but I like to get the closest base colour and then use a spray to achieve an exact match for a flawless result.

A smaller sensor, sometimes referred to as 'mini' and measuring either 16 or 18mm in size (if I recall correctly), is available. However, I have found these smaller sensors to be much less dependable.

Access the reverse light circuit by connecting to the wiring at the North/South rear light. Then, pass the wires through the grommet located at the bottom North/South section of the back panel. I have a preference for soldering the wire instead of using a Scotchlok. There is no need to remove the bumper. It typically takes me around 30-40 minutes, excluding the time spent spraying the sensors prior. Place the controller/buzzer discreetly under the rear trim panel. It produces a loud sound, so you may need to use tape to muffle the noise. The sensors are attached to a compact tail with a connection, allowing for easy removal and replacement in the event of a failure or damage, without the need to disassemble the whole system.

[vendimoto55]

Can be simply done as a do-it-yourself project.

Purchase a parking sensor kit on Amazon within the price range of 15 to 20 pounds. The set is equipped with drill bits. Create four perforations on the bumper. Attach the sensors to the bumper. Thread the sensor cables through the rubber grommet and into the boot. Securely attach it to the device.

The most challenging aspect is supplying electricity to the device. You will need to connect the red wire to the reverse light by checking the lines that go to the rear left lights. The black wire should be connected to the body ground.

This kind of task typically takes around 2 hours of my time. (I have a tendency to strive for perfection and spend a significant amount of time carefully measuring the places for drill holes.)

If you bring the vehicle to a garage, the labour cost, which ranges from 1.5 to 2 hours, will be added along with the value-added tax (VAT). This will amount to a total cost of £100 to £160.

I charge £30 due of my non-professional status in the automotive industry. It is akin to a pastime.

[Thomas_Green78]

If your Aygo is equipped with a tow bar, some further electrical modifications may be necessary. However, this is not always the case.

[dontito]

Since Aygos lack the ability to tow, there will not be any towing equipment installed on them.

[almamater78]

Do they have permission to transport bicycles? That is the only purpose for which I use my tow bar.