What is the optimal sequence for reassembling the components from the sub to the knuckle, to avoid obstructions and prevent additional labour?
Every single component is undergoing replacement, including the knuckles. I assume that I cannot fully tighten any control arms, droplinks, etc., until the vehicle is at simulated ride height.
I anticipate that someone will remark 'the contrary of disassembly,' yet I was not preserving any components while I dismantled the sub, and Mr. Grinder was predominantly utilised for everything.
I simply wish to avoid inflicting any undue strain on the bushes or the wheel bearings. The subwoofer remains connected to the vehicle, by the way.
Salutations.